Garage Door Spring Repair & Replacement in Houston, TX
The loudest failure in your house, fixed the same day it happens.
A torsion spring is the only thing holding up 150 to 400 pounds of steel. It is wound to a precise number of turns for your exact door weight, and it is rated in cycles — one up, one down — not years. Builder-grade springs are rated at 10,000 cycles. A family that leaves twice a day and comes home twice a day burns through that in about seven years. Then it goes, usually with a bang like a gunshot, and the door becomes immovable.
What you get
- Springs sized by measured door weight, wire gauge and drum — not guessed
- We replace in matched pairs so the door stays balanced
- High-cycle 25,000-turn upgrade available on any door
- Cables, bearings and drums inspected on the same visit at no extra charge
- Same-day service across Greater Houston — this is the repair we drop everything for
- Two-year warranty on standard springs, five years on high-cycle
How we do it
We weigh the door, not eyeball it
The right spring is a function of door weight, height, track radius and drum size. We measure. A spring that is 10 pounds off will run rough and die early, and it is the single most common thing we find wrong with someone else's recent install.
Wound to spec with proper bars
Winding bars, not screwdrivers. Every turn counted, cones set and torqued, set screws to spec. This is the part of the job that hurts people who try it themselves, and it is why we do not sell springs over the counter.
Balanced and cycle-tested
Opener disconnected, door lifted by hand, and it has to hold still at knee height, waist height and shoulder height. Then twenty full cycles on the opener before we pack up.
Signs you need spring repair
- A loud bang from the garage, and now the door will not lift
- A visible gap of two or three inches in the spring coil above the door
- The door lifts a few inches then stops or falls back down
- The opener strains, hums, or the motor runs while the door barely moves
- The door slams shut the last two feet instead of settling
- One side of the door lifts higher than the other
Spring Repair pricing in Houston
| Option | Installed price | What it is |
|---|---|---|
| Single torsion spring — replaced | $220 – $380 | Standard residential torsion spring, sized to your door weight and drum. Includes balance test and full hardware check. |
| Pair of torsion springs — replaced | $380 – $560 | The one we recommend. Springs wear as a matched set; replacing both means the door stays balanced and you are not back here in eight months. |
| Extension springs — pair | $190 – $340 | For older side-mounted systems. Always installed with containment cables so a break cannot send steel across the garage. |
| High-cycle spring upgrade | $480 – $720 | 25,000-cycle springs instead of the builder-grade 10,000. Roughly triple the life for about 40% more — the right call on a door that cycles four times a day. |
Prices are for standard residential doors in the Greater Houston area and are confirmed in writing on site before any work begins.
Problems this fixes
Spring Repair across Greater Houston
We run spring repair calls across all 47 cities we serve — from The Woodlands in the north to Lake Jackson in the south, and out to Mont Belvieu in the east. Same flat pricing, same warranty, wherever you are.
What customers said
“We replaced a beat-up builder door with an insulated carriage style. The garage is genuinely cooler now and you can barely hear it open from the kitchen. They showed us renderings on our actual house before we picked.”
“Two other companies quoted me a whole new opener. This guy pulled the cover, showed me the shredded gear, replaced the kit for a fraction of that, and told me the unit had years left. Honest is rare in this trade.”
“Our bedroom is over the garage and the door woke the baby every single morning. Nylon rollers, new hinges, proper lubrication — under two hundred dollars and it is now genuinely quiet. Should have called two years ago.”
Spring Repair — your questions
How much does a garage door spring cost in Houston?
One torsion spring replaced runs $220 to $380 installed. Both springs — which is what we recommend — runs $380 to $560. High-cycle springs that last roughly three times as long run $480 to $720 for the pair. Every price includes the balance test and a full hardware inspection.
Can I replace a garage door spring myself?
Please do not. A torsion spring holds several hundred pounds of stored energy and is wound under tension with steel bars. Broken wrists, lost teeth and worse are common enough that every manufacturer prints a warning on the spring itself. It is a 60-minute job for someone with the right bars and the wrong 60 minutes for everyone else.
Should I replace one spring or both?
Both. They were installed the same day, they have taken the same number of cycles, and the second one is on borrowed time. Replacing both costs far less than two separate service calls, and it keeps the door balanced — an unbalanced door destroys the opener next.
How long do garage door springs last in Houston?
Seven to ten years on a standard 10,000-cycle spring for an average family. Houston shortens that: the humidity off the Gulf rusts the coil, and rust is what actually starts the crack. Springs on unconditioned garages near the bay go earlier. Annual lubrication is the cheapest thing you can do about it.
Can I still use my door with a broken spring?
No — and forcing the opener to do it will burn out a $400 motor to save a $300 spring. If your car is trapped inside, call us and we will get you out safely today.
Need spring repair today?
Flat pricing, 4.9★ service, and a Houston crew that answers the phone.
